62
Display language selection
Once you have selected the work conguration you may select
the display language.
To change the language, from inside the USER MENU scroll down till
you nd Menu - 6 LANGUAGE.
5 R A D I O I n f o
>> 6 L A N G U A G E <<
Press the black “ENTER” button .
Scroll down until you nd your language (for example English)
and conrm your choice by pressing the black “ENTER” button
.
Using the power lift
“WARNING: if you press a button before 2 seconds have passed
since the previous command was released, the selected
command will not be activated and the display will show:
H e i g h t 1 1 1 1 mm
C M D N O T P O S S I B L E
Ascent, active on all activated columns
H e i g h t 0 0 0 0 mm
UP A L L
H e i g h t 0 0 0 0 mm
UP GROUP
Descent, active on all activated columns
H e i g h t 1 1 1 1 mm
DOWN A L L
H e i g h t 1 1 1 1 mm
DOWN GROUP
Slow descent, active on all activated columns
H e i g h t 1 1 1 1 mm
SLOW DOWN A L L
H e i g h t 1 1 1 1 mm
SLOW DOWN GROUP
Single (double button), active only by “ ALL”
H e i g h t 0 0 0 0 mm
U P S I N G L E
If the truck is misaligned by over 40 mm
when the command is released, the display shows:
H e i g h t 1 1 1 1 mm
A L I G N M E N T F A I L
if an ascent or descent button is pressed
the display shows:
H e i g h t 1 1 1 1 mm
C M D N O T P O S S I B L E
to move all, it is rst necessary to recover
the misalignment individually.
After the operation, the display shows:
H e i g h t 1 1 1 1 mm
A L L
Indicate the height of the column expressed in mm. _______________
H e i g h t 1 1 1 1 mm
D O W N S I N G L E
H e i g h t 1 1 1 1 mm
S L O W D O W N S I N G L E
7
(VARSC)
M E N U USER
I T A L I A N O
>> ENGLISH <<
0526-M002-3
To Next Page
Loading...
