Ravaglioli RAV307H.4WS-VARSC - Page 64

64
and on the columns excluded from the group:
H e i g h t 1 1 1 1 mm
E S C L U D E D C O L U M N
The Ascent, Descent and Slow Descent commands are only available for the columns in the group; all other columns remain
stationary. The single and parking commands are not available (“CMD NOT POSSIBLE”).
This mode allows operations with regard to other columns that make up the power lift only on columns belonging to a group.
These offsets are maintained during any subsequent operations in ALL mode.
D) From “GROUP” mode to “ALL” mode
1) the display shows:
H e i g h t 1 1 1 1 mm
G R O U P
Press the black “ENTER” key
the following is displayed:
1 A l l M o d e
> >
2 G r o u p M o d e
< <
move up with the yellow key , to
> > 1 A l l M o d e < <
2 G r o u p M o d e
conrm with the black “ENTER” key
the following is displayed:
> > A L L R E Q ? < <
E x i t
conrm with the black “ENTER” key
Selecting the ALL mode, the following is displayed:
> > A L L M O D E < <
S E L E C T E D . .
2) Repeat the operations on all the columns that are entered in GROUP mode.
- ATTENTION: If the columns in “GROUP” mode are turned off and then turned on again, they will be set to “ALL” mode.
Simultaneous conguration of two or more power lifts
It is not possible.
If 2 master columns with open conguration are detected, the procedure is blocked.
All installations must be switched off.
Repeat the operation, close the conguration of the bridge before starting the set of a new machine.
7
(VARSC)
0526-M002-3