Removing the battery and Cleaning the 12 Volt Battery Terminals
a. Remove the 5 bolts from the right side panel using an 8mm wrench, then remove the panel.
b. Use an 8mm wrench (not included) to remove the two bolts securing metal bracket around the battery, then remove the bracket.
c. Use an insulated 10mm wrench (not Included) to loosen the bolt on the negative (Black) battery terminal.
d. Remove the wires and repeat for the positive (Red) terminal.
e. Remove the battery from the MPV.
f. Clean the terminals and the battery cable ends with a wire brush or replace the battery if necessary. On l y u s e a 12 V – 9 AH
r e p l a c e m e n t b a t t e r y .
g. Fit the battery into position and connect the positive (red) wires to the positive (+) terminal and tighten the bolt.
h. Reconnect the negative (black and green) wires to the negative (-) terminal and tighten the bolt.
i. Reassemble the battery retainer and vehicle side cover.
RAVEN MPV-7100/7100S OWNER’S MANUAL
servICe & MaIntenanCe
Servicing the 12 Volt Starter Battery and Terminals
The 12 volt starter battery is located on the right side of the MPV, in front of the rear wheel. Always keep batteries and terminals
clean and free of corrosion and dirt.
4 0
Re m o v e 8 m m B o l t s
Re p l a c e 8 m m B o l t s
Re m o v e 8 m m B o l t s
Re m o v e 10m m B o l t
o n B l a c k T e r m i n a l
Re m o v e 10m m B o l t
o n Re d T e r m i n a l
B a t t e r y
B r u s h
Re d
T e r m i n a l
B l a c k
T e r m i n a l
T e r m i n a l s
A
D
G
B
E
H
C
F
I
To Next Page
Loading...
Need help?
General