Raven MPV-7100 User Manual

Removing the Cutting Deck
a. Ensure the MPV is turned off with the key removed.
b. Lower the cutting deck completely to the ground using the deck lift lever.
c. Disconnect the deck power plug.
d. Disconnect the front pin, then disconnect the two rear pins.
e. Raise the deck lever to the highest position.
f. Slide the deck out from beneath the MPV.
RAVEN MPV-7100/7100S OWNER’S MANUAL
Deck Maintenance
The cutting deck must be removed when changing the blades. Removing the deck will not change the deck height
settings. The deck is pre-set at the factory for grass requiring higher cut lengths. You may choose to set the deck height
to a lower cutting height if necessary.
servICe & MaIntenanCe
3 0
BA
C
E
D
F
St o p En g i n e
D i s c o n n e c t Pl u g
Sl i d e D e c k Ou t
Re m o v e K e y
Lo w e r D e c k t o
Lo w e s t Po s i t i o n
Pu l l
Pi n s
Ra i s e D e c k t o
H i g h e s t Po s i t i o n

Raven MPV-7100 Specifications

General

Brand	Raven
Model	MPV-7100
Category	Offroad Vehicle
Language	English