Attaching the Cutting Deck
a. Ensure the MPV is turned off with the key removed.
b. Check that the Deck lift lever is in the lowest position, then slide the deck under the MPV.
c. Place the deck lift lever into the lowest setting.
d. Align and connect the front and rear pins.
e. Connect the deck power plug.
f. Raise and lower deck as needed.
WWW. RAVENAMERI C A. C OM
servICe & MaIntenanCe
3 1
BA
C
E
D
F
St o p En g i n e
Re c o n n e c t Pl u g
Sl i d e D e c k Un d e r
D e c k
Re m o v e K e y
Re p l a c e
Pi n s
Lo w e r D e c k t o
Lo w e s t Po s i t i o n
Ra i s e D e c k t o
H i g h e s t Po s i t i o n
To Next Page
Loading...