EasyManuals Logo

Raven RCM Calibration And Operation Manual

Raven RCM
30 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #6 background imageLoading...
Page #6 background image
CHAPTER 1
2 RCM-Sprayer Ratio Rate (without Boom Control) Calibration and Operation Manual
Always wear appropriate personal protective equipment as recommended by the chemical and/or equipment
manufacturer.
When storing unused agricultural chemicals:
Store agricultural chemicals in the original container and do not transfer chemicals to unmarked
containers or containers used for food or drink.
Store chemicals in a secure, locked area away from human and livestock food.
Keep children away from chemical storage areas.
Fill, flush, calibrate, and decontaminate chemical application systems in an area where runoff will not reach
ponds, lakes, streams, livestock areas, gardens, or populated areas.
Follow all label instructions for chemical mixing, handling, and disposal.
Avoid direct contact with agricultural chemicals or inhaling chemical dust or spray particulate. Seek immediate
medical attention if symptoms of illness occur during, or soon after, use of agricultural chemicals or products.
After handling or applying agricultural chemicals:
Thoroughly wash hands and face after using agricultural chemicals and before eating, drinking, or
using the restroom.
Thoroughly flush or rinse equipment used to mix, transfer, or apply chemicals with water after use
or before servicing any component of the application system.
ELECTRICAL SAFETY
Always verify that power leads are connected to the correct polarity as marked. Reversing the power leads
could cause severe damage to the Raven system or other components.
To prevent personal injury or fire, replace defective or blown fuses with only fuses of the same type and
amperage.
Do not connect the power leads to the battery until all system components are mounted and all electrical
connections are completed.
Always start the machine before initializing this Raven system to prevent power surges or peak voltage.
To avoid tripping and entanglement hazards, route cables and harnesses away from walkways, steps, grab bars,
and other areas used by the operator or service personnel when operating or servicing the equipment.
CAUTION

Other manuals for Raven RCM

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Raven RCM and is the answer not in the manual?

Raven RCM Specifications

General IconGeneral
BrandRaven
ModelRCM
CategoryControl Unit
LanguageEnglish

Related product manuals