Loading Document(s) in the ADF
Document Feeding
1. Load the stack of documents face down with the top of the
pages pointing into the feeder.
2. Verify that the paper guides are aligned with the edges of the
stack by sliding the paper feed guides in the automatic
feeder tray.
Feeding Tips
To avoid occasional multi-feeds or paper jams, please fan your
documents and align the top edges before feeding them into the
scanner.
1. Hold both ends of the documents and fan them a few
times.
2. Rotate the documents by 90 degrees and fan them in the
same manner.
3. Align the edges of the documents in a step-like pattern
(see picture).
If you need to scan longer documents, pull out the paper chute
extension and stacker to provide further support for the
documents.
Attention
● DO NOT load more than 50 sheets of paper (70 g/m2, 18 lb.) to the ADF.
● Paper scanned from the ADF must be a minimum of 5.08 x 5.08 cm (2” x 2”, W x
L).
● Make sure there are no gaps between the document stack and the paper-width
slider; otherwise, the scanned images can be skewed.
● Although the documents should be loaded firmly in place ensuring optimum
scanning accuracy, they should never be wedged in so tightly that the process of
feeding them through the scanner is strained.
● Do not load additional paper into the ADF while the unit is feeding and scanning.
18
To Next Page
Loading...
