Scanning Plastic Cards
The plastic card can be an embossed credit card, driver license, ID card, insurance card,
medic-care card or any membership card. Make sure to load the embossed face of the
embossed card face up into the scanner. When scanning multiple embossed cards, the
pad module can be removed to ease the scanning process. To remove the pad module,
please refer to the following instruction:
1. Open the panel unit by pulling the panel unit open lever.
2. Remove the pad module by pinching both sides of the pad module and pull it out.
3. Close the panel unit by pushing it back down until it snaps back into place.
4. Horizontally load the plastic card, headfirst and face up, toward the center of the
ADF.
5. Make sure to load the embossed face of the embossed card face up into the
scanner.
6. For double-sided scans, load the card in desired order.
7. Adjust the paper width slider to the card width. The paper width slider should be
gently touching both sides of the card.
20
To Next Page
Loading...
