6.Vehicle Usage Instructions
P Mode Parking Function
1) Enter the P-gear parking position upon startup.
2) When the side stand is lowered, enter the P mode parking position.
Note: Before squeezing the brake lever to activate the P mode parking function, ensure the side
stand is open!
Vehicle "Power Off" (Power On but Not Engaged)
1) Turn off the brake power: Grip the brake lever, return the handle to its position, and the motor
will have no output.
2) Motor overheating protection.
3) Controller overheating protection.
4) Battery overheating, power reaching undervoltage protection point.
Vehicle Power Reduction
1) Controller overheating (begins deceleration when operating temperature exceeds 85°C; reduces
output by 10% for every additional 1°C. If overheating persists, power output reduces to 20%
of rated value; can be reused after controller cools).
2) Motor overheating (begins derating process when operating temperature exceeds 110°C;
derating value increases by 10% for every additional 1°C. If overheating continues, power
output reduces to 20% of rated value; wait for motor to cool down before reuse).
3) Battery voltage linearly reduces from 71V; decreases by 20% for each 1V reduction, minimum
derated to 15% of rated value. Battery enters undervoltage protection at 63V.
4) Power output stops when power is zero. (If not charged in time to continue use, battery may
enter overdischarge protection.) Note: After overdischarge protection, battery needs to be
charged and activated with a charger; activation method is detailed in Fault Phenomenon on
P35, Item 7.
Environmental Conditions During Use
Not recommended to use sports equipment at temperatures below 0°C to -20°C; battery equivalent
to 80% at room temperature.
Avoid prolonged high-power driving when temperatures exceed 50°C.
Water Involvement
Occasional water contact (up to 24 cm / 9 inches deep) is acceptable for all-terrain electric
motorcycles, but prolonged immersion is not recommended. Especially when the motor is hot,
water cooling and internal air contraction can cause water to seal oil and absorb into cable positions,
leading to internal damage.
Below are the waterproof ratings for each component:
Battery, Motor: IP65
Controller: IP67
Vehicle connectors: IP65
To Next Page
Loading...