3.Quick Installation Guide
Do not assemble, disassemble, or package the all-terrain electric motorcycles individually.
Team cooperation is required.
2) Place the handlebars on the
headlight bracket, aligning the
holes, and secure with the 4 bolts
using a 5# hex key wrench.
Note: Be sure to use washers with the 4 bolts.
Install the handlebars
1)
Place the headlight bracket onto
the upper mounting plate,
aligning with the four holes, then
tighten the clamping nuts into the
slots in front of the headlight
bracket.
Handlebar adjustment:
1) Use a 3# hex key wrench to loosen the
2 bolts, then rotate the handlebars to
the desired angle.
2) Use a 5# hex key wrench to loosen the
4 bolts, adjust the handlebar angle.
Note: Do not lose the washers securing the
bolts.
To Next Page
Loading...