Installation of brake lever and
throttle
1) As shown in the diagram, adjust
the front brake lever and throttle to
an angle of 25 ° -35 ° that is
comfortable for your grip distance.
1) Use a 4# hex key wrench to
secure and adjust the angle of the
brake lever.
Use a Phillips screwdriver to
secure the throttle.
3) Rotate the speed control handle to
ensure it returns to its normal
position and can accelerate
inward.
Note: If stuck, check the speed
control handle.
Note: Installation steps for the rear
brake lever and left function switch
are the same as the above steps.
To Next Page
Loading...