Raymarine 530 - Page 10

x SL520/530/631 PLUS Chartplotter Displays
GPS SOG/COG Filter ................................................................. 5.10
Compass Set Up .......................................................................... 5.10
Language .................................................................................... 5.10
Simulator .................................................................................... 5.10
5.4 Chart Set Up Parameters...............................................................5.11
Customize Chart ..........................................................................5.11
Plotter Mode ............................................................................... 5.12
Chart Orientation ........................................................................ 5.12
Object Information ..................................................................... 5.13
Waypoint Options ....................................................................... 5.13
Vectors ........................................................................................ 5.13
Radar/Chart Synch ...................................................................... 5.13
Datum Selection ......................................................................... 5.13
Position Offset ............................................................................ 5.14
Chapter 6: Installation ......................................................................................6.1
6.1 Introduction .................................................................................. 6.1
Planning the Installation ............................................................... 6.2
EMC Installation Guidelines ........................................................ 6.2
6.2 Unpacking and Inspecting the Components ................................. 6.4
6.3 Selecting the Display Unit Location ............................................. 6.5
6.4 Cable Runs .................................................................................... 6.9
Power Cable .................................................................................. 6.9
6.5 Mounting the Display Unit ......................................................... 6.10
6.6 System Connections ................................................................... 6.12
Display Unit Connection ............................................................ 6.13
6.7 System Checks and Inital Switch On .......................................... 6.15
System Check ............................................................................. 6.15
Switch On and Initial Setup ........................................................ 6.15
EMC Conformance ..................................................................... 6.16
6.8 Integrated Systems ...................................................................... 6.17
SeaTalk® and NMEA In ............................................................. 6.18
Using the SeaTalk Auxiliary Junction Box ................................. 6.21
Data Output ................................................................................. 6.22
Data Conversion ......................................................................... 6.23