Raymarine E-Series - Page 16

MULTIFUNCTION DISPLAYS
If you are looking to refit your boat or upgrade your current Raymarine displays to the new e
or c Series displays,wecanhelpmakelifeeasierforyou!
New e or c Series displays are available with optional easy-fit bezels, complete with
mountingplates,forusewhenreplacingC/E80/120ClassicorC/E90/120Widescreendisplays,
so there is no need to cut new holes or fit a new dash.
UPGRADE OR REFIT TO NEW e OR c SERIES DISPLAYS
Optional easy-fit bezels available to
upgradefromC90W,C120W,
E90WandE120W
Upgrading is simple – using optional easy-fit bezels
1. Remove your old Raymarine display from the dash.
2. Screwthenewmountingplate(suppliedpre-drilled)totheoldxingholes.
3. Remove the outer bezel from your new e or c Series display.
4. FittheNEWdisplayintothemountingplateandscrewdown.
5. Cliptheneweasy-tbezelontotheNEWdisplay.
Stand back and admire your handiwork!
PHOTO COURTESYRIVIERA
Optional easy-fit bezels available to
upgradefromC/E80andC/E120Classic
14