6
Check wireless coverage
You must survey the wireless coverage to ensure that each wireless
keyboard can operate in the intended area.
Connect power to base station
Site the base station at the required location and make a temporary
switched connection to the power supply.
Register Keyboard to base station
Register an unregistered keyboard to the required base station.
1. Turn off all base stations and keyboards within range.
2. Turn on the appropriate base station.
3. Within one minute turn on the unregistered keyboard.
(This must be within range of the base station.)
4. The keyboard attempts to register.
5. Once the base station is detected, the keyboard display shows
the signal strength.
e.g.
The keyboard is now registered.
Note: It is important that NO additional wireless keyboards or base
stations are turned on during registration. This will prevent
accidental registration of the wrong device or base station.
Check signal strength
1. Press the button (located under the outer cover of the base
station) to initiate site survey mode.
2. Slowly move the keyboard around the required area of the
vessel, confirming that the signal strength indicator maintains a
strong signal (i.e 3 bars).
3. If the signal strength is not maintained, re-position the base
station and repeat the survey.
4. Turn off the base station once the survey is complete.
D10689-1
Wireless
basestation
Black
Red
Temporary
power
connection
Screen
12 V dc,
5 A fuse supply
Power cable
87086_1.book Page 6 Thursday, October 4, 2007 8:47 AM
To Next Page
Loading...
