3-76 Operations
3.5.30.5.5 ATIS Set Up
This operation determines whether to effect ID transmission of ATIS after
the PTT switch is released.
To set the ATIS function:
1. Per the description in Section 3.5.30.5 Setting Operation (RAY230E)
above, select ATIS.
2. Press the ENT key. The message ATS is shown on the 7-segment
display and ATIS OFF appears on the dot matrix.
3. Press the SQ UP/DOWN key to toggle between ATIS ON and ATIS
OFF.
4. After selecting the desired operation, press the ENT key.
5. If the setting is acceptable, press the ENT key to confirm. The message
CONT? Y is displayed.
6. Press the ENT key to register the setting. When ATIS is ON, the ATIS
indicator is illuminated on the LCD.
To exit without making changes, press the SQ UP/DOWN key until DEL?
N is displayed. Press the ENT key and operation returns to the mode
before the Menu operation began.
ENT ENT
3.5.30.5.6 Siren Set Up
The operation is identical to the Siren set up operation described for the
RAY230 in section 3.5.30.4.3 Siren Set Up.
To Next Page
Loading...
