Chapter 6: Adjusting Autopilot Settings 73
6 Adjusting Autopilot Settings
Dealer Calibration: default settings with Type 100/300
Calibration setting Vessel type
1 = Displacement
2 = Semi Displacement
3 = Planing
4 = Stern drive (I/O)
Your settings
Vessel type 1234
Calibration lock 0000
Rudder gain 5543
Counter rudder 7775
Rudder alignment 0000
Rudder limit 30303020
Turn rate limit 20 15 15 8
Cruise speed 6 8 15 15
Off course angle 20202020
AutoTrim 2333
Power steer OFF OFF OFF OFF
Drive type 3443
Rudder damping 2222
Variation OFF OFF OFF OFF
AutoAdapt NORTH NORTH NORTH NORTH
Latitude 0000
Wind Trim
(displacement only)
1 --- --- ---
AutoRelease
(stern drives only)
--- --- --- ON
Response 1111
Note: Information applies to Type 100/300 Course Computers with Version 15 software.
81013_4.book Page 73 Wednesday, July 25, 2001 11:04 AM
To Next Page
Loading...
