12 SmartPilot X-5 Sport Operating Guide
Accessing response setup
You can access the User calibration mode only from Standby mode, so to set the
response level:
1. Ensure the SPX-5 Sport system is in Standby mode, then hold down
standby
for
2 seconds. The display will change to show
DISPLAY CAL
.
2. Press
disp
once. The display will now show
USER CAL
.
3. Press
auto
to enter User calibration.
The Response setup page is displayed.
4. To access other User calibration pages, press
disp
to scroll through the
calibration functions (described below).
5. Use the -1, +1, -10 and +10 buttons to change the value of each function you want
to change.
6. When you have made all the changes you want to make, hold down
standby
for
two seconds to exit calibration mode and save changes.
81293_3.book Page 12 Tuesday, August 25, 2009 7:53 AM
To Next Page
Loading...
