26 ST4000+ Wheel & Tiller Autopilots: Owner’s Handbook
3 Advanced Operation
2. Select the data page you want to use as the principle display on the
control unit:
• the current autopilot mode is shown at the left of the display
and the autopilot bar graph remains in use
• if you then select a new mode or make a course change, the
autopilot mode screen appears as a ‘pop-up’ for 5 seconds
Three data pages are set in the factory as a default (see diagram).
Within User setup you can select up to seven pages and control the
information they display (see page 90):
• if the autopilot system cannot obtain the required information for
a data page, the display will show dashes instead of a value
• the ‘direction-to-steer’ arrows relate to the data page information
• most data pages show repeated data so you cannot adjust them:
the exceptions are the RESPONSE and RUDDER GAIN data pages
(if you have selected them for display) which you can adjust
using the -1 and +1 keys
D3314-2
Autopilot mode
Data page 1Data page 3
Data page 2
Default data pages
81131_7.book Page 26 Wednesday, March 17, 2004 3:59 PM
To Next Page
Loading...
