Raymarine ST2000+ User Manual

ST1000+ and ST2000+ Quick Reference Guide
Auto mode
Track mode
WindTrim mode
Autopilot displays
or
or
1 sec
and and
and
and
and
and
and
or
Basic operation
Entering Track mode (from Auto or Wind Vane mode)
Making course changesExtending/retracting the pushrod
Course
changes
to port
Course
changes to
starboard
Entering WindTrim mode
1˚
10˚
Switching lighting on/off
(from Standby mode only)
Switching AutoSeastate on/off
(from Auto/Track/WindTrim modes)
Displaying navigation data
(from Auto or Standby modes)
to accept new heading
to enter Track mode
and
Wait 10 sec to return to previous mode. Press -1 and +10 together to exit.
D3364-2
then
then
Returning to Standby (Disengaging the autopilot)Entering Auto mode (Engaging the autopilot)
Returning to previous locked heading
again to accept heading
Press to
switch between:
Press to
switch between:
OFF
ON
OFF
ON
Using AutoT
ack
AutoTack
to port
(100˚)
AutoTack to
starboard
(100˚)
Press standby or auto to exit WindTrim mode.
Press standby or
auto to exit.
Use any of these keys to
extend or retract the pushrod
86022_2.fm Page 1 Monday, July 9, 2001 12:10 PM

Raymarine ST2000+ Specifications

General

Type	Tiller Pilot
Power Supply	12 V DC
Waterproof Standard	IPX6
Display Type	LCD
Data Interface	SeaTalk
Compass Type	Fluxgate
Drive Unit Type	Linear
Operating Temperature	-10°C to +55°C
Heading Resolution	1 degree
Storage Temperature	-20°C to +70°C
Stroke	240 mm (9.5")

Summary

Basic Operation Modes

Auto Mode Functions

Covers engaging Auto mode, making course changes, and returning to previous headings.

Track Mode Functions

Details entering Track mode and using the AutoTack feature for course adjustments.

WindTrim Mode Functions

Explains how to enter WindTrim mode for sail trim management.

Autopilot Display Information

Describes navigation data display, lighting control, and AutoSeastate settings.

Compass Calibration Procedure

Entering and Initiating Calibration

Steps to enter compass calibration mode and start the boat turning process.

Calibrating Heading Alignment

Adjusting the autopilot heading to match the boat's steering compass accurately.

Saving or Quitting Calibration

Options to save calibration settings or quit the process without changes.