Raymarine ST4000+ - Chapter 7: Customizing the ST4000+

Chapter 7: Customizing the ST4000+ 89
7 Customizing the ST4000+
Chapter 7: Customizing the ST4000+
The ST4000+ provides calibration options that you can use to adjust
the settings for the control unit, the compass and the autopilot system.
We calibrate the ST4000+ during manufacture to provide stable
performance for most boats so you can perform the initial sea trial.
After you have completed the initial installation and sea trial, you
should not normally need to alter the Dealer setup values. However, if
sailing conditions change you may need to adjust the settings.
Note: Complete the procedures described in Chapter 6: Setting-up
the ST4000+ before adjusting any calibration settings.
Accessing the setup modes
Note: See page 32 for more information about the software version
screen.
D5335-1
SECONDS
User setup Software version Dealer setup
SECONDS SECONDS
81131_7.book Page 89 Wednesday, March 17, 2004 3:59 PM