EasyManua.ls Logo

Raypak CROSSWIND-40-I - User Manual

Raypak CROSSWIND-40-I
28 pages
Save Page as PDF
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
Loading...
Catalog No. 6100.64
E󰀨ective: 11-15-19
Replaces: New
P/N 241827 Rev.1
INSTALLATION
AND OPERATION
MANUAL
FOR YOUR SAFETY: Do not store or use gasoline or other ammable vapors and
liquids or other combustible materials in the vicinity of this or any other appliance. To
do so may result in an explosion or re.
Crosswind
Side Discharge
Heat Pump Pool Heater
NOTE: The instructions in this manual are for the use of qualied individuals specially trained and experienced
in the installation and maintenance of this type of equipment and related system components. Installation and
service personnel are required by some states to be licensed. Persons not qualied shall not attempt to install,
service, or maintain this equipment.
This manual should be maintained in legible condition and kept adjacent to the heat pump pool heater or in a
safe place for future use.
Inverter Models
CROSSWIND-30-I through -65-I
On/O󰀨 Models
CROSSWIND-40-O through -65-O
(Canada Only)
6100.64_Crosswind.indd 1 11/26/2019 4:16:40 PM

Table of Contents

Questions and Answers

  • B
    Brandon DuncanAug 7, 2025
    What to do if Raypak Swimming Pool Heater runs but does not heat?
    • H
      Heather RodriguezAug 7, 2025
      If your Raypak Swimming Pool Heater's heat pump runs but doesn't heat, ensure that neither the air inlet nor the air outlet are blocked by any obstructions. Also, check that the temperature isn't set too low and adjust the temperature setting if needed. If the unit has just been started, wait at least three minutes for the warming process to begin, as it may be in a protection mode.
  • W
    Wayne WilliamsAug 21, 2025
    How to fix Raypak Swimming Pool Heater if it does not run?
    • S
      Samantha WhiteAug 21, 2025
      If your Raypak Swimming Pool Heater's heat pump does not run, first, ensure that the main power is on. If it is, check whether the power switch is turned on. Also, inspect the fuse and replace it if it's burnt. Finally, verify that the circuit breaker hasn't tripped, and if it has, turn it back on. Wait for the power to be restored if it's off.

Summary

WARNINGS

General Safety and Warning Terms

BEFORE INSTALLATION

Installation Requirements and Chemical Handling

Covers installation considerations, chemical feeder guidelines, and pool water chemistry requirements.

ELECTRICAL WIRING

Electrical Wiring and Automation Connections

Details electrical installation, connections, and automation control wiring for inverter models.

WIRING DIAGRAM

Wiring Diagrams for Model Series

OPERATING INSTRUCTIONS

Heater Start-Up and Operation Procedures

TROUBLESHOOTING

Troubleshooting Common Faults and Error Codes

Lists common failures, their reasons, solutions, and detailed fault codes for Inverter and On/Off models.

TECHNICAL PARAMETERS

Technical Specifications by Model

Raypak CROSSWIND-40-I Specifications

General IconGeneral
BrandRaypak
ModelCROSSWIND-40-I
CategorySwimming Pool Heater
LanguageEnglish

Related product manuals