What to do if Raypak Swimming Pool Heater runs but does not heat?
If your Raypak Swimming Pool Heater's heat pump runs but doesn't heat, ensure that neither the air inlet nor the air outlet are blocked by any obstructions. Also, check that the temperature isn't set too low and adjust the temperature setting if needed. If the unit has just been started, wait at least three minutes for the warming process to begin, as it may be in a protection mode.
How to fix Raypak Swimming Pool Heater if it does not run?
If your Raypak Swimming Pool Heater's heat pump does not run, first, ensure that the main power is on. If it is, check whether the power switch is turned on. Also, inspect the fuse and replace it if it's burnt. Finally, verify that the circuit breaker hasn't tripped, and if it has, turn it back on. Wait for the power to be restored if it's off.
Defines hazard alert symbols used throughout the manual for safety.
Provides essential safety guidelines for operating the pool heater safely.
Specific requirements and clearances needed for proper and safe installation of the unit.
Step-by-step guide for starting the pool heater correctly.
Lists common issues and their potential solutions for the heat pump.
Explains error codes displayed by the unit and their meanings.
Comprehensive data on heating capacity, power, dimensions, and other technical specs.
Detailed performance data for inverter models including capacity, COP, and power.
Detailed performance data for On/Off models including capacity, current, and noise levels.
General| Model | CROSSWIND-50-O |
|---|---|
| Type | Swimming Pool Heater |
| Fuel Type | Natural Gas or Propane |
| Voltage | 120V |
| Efficiency | 82% |
| Heating Capacity | 50, 000 BTU/hr |
To Next Page