EasyManua.ls Logo

Raypak CROSSWIND-65-I - User Manual

Raypak CROSSWIND-65-I
28 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
Loading...
Catalog No. 6100.64
E󰀨ective: 11-15-19
Replaces: New
P/N 241827 Rev.1
INSTALLATION
AND OPERATION
MANUAL
FOR YOUR SAFETY: Do not store or use gasoline or other ammable vapors and
liquids or other combustible materials in the vicinity of this or any other appliance. To
do so may result in an explosion or re.
Crosswind
Side Discharge
Heat Pump Pool Heater
NOTE: The instructions in this manual are for the use of qualied individuals specially trained and experienced
in the installation and maintenance of this type of equipment and related system components. Installation and
service personnel are required by some states to be licensed. Persons not qualied shall not attempt to install,
service, or maintain this equipment.
This manual should be maintained in legible condition and kept adjacent to the heat pump pool heater or in a
safe place for future use.
Inverter Models
CROSSWIND-30-I through -65-I
On/O󰀨 Models
CROSSWIND-40-O through -65-O
(Canada Only)
6100.64_Crosswind.indd 1 11/26/2019 4:16:40 PM

Questions and Answers

  • M
    Mr. Michael BennettAug 7, 2025
    What to do if Raypak Swimming Pool Heater runs but does not heat?
    • E
      ehansenAug 7, 2025
      If your Raypak Swimming Pool Heater's heat pump runs but doesn't heat, ensure that neither the air inlet nor the air outlet are blocked by any obstructions. Also, check that the temperature isn't set too low and adjust the temperature setting if needed. If the unit has just been started, wait at least three minutes for the warming process to begin, as it may be in a protection mode.
  • P
    parrishkatherineAug 23, 2025
    How to fix Raypak Swimming Pool Heater if it does not run?
    • B
      Brian CalderonAug 23, 2025
      If your Raypak Swimming Pool Heater's heat pump does not run, first, ensure that the main power is on. If it is, check whether the power switch is turned on. Also, inspect the fuse and replace it if it's burnt. Finally, verify that the circuit breaker hasn't tripped, and if it has, turn it back on. Wait for the power to be restored if it's off.

Summary

WARNINGS

Pay Attention to These Terms

Defines warning terms like DANGER, WARNING, CAUTION, and NOTE for hazard identification.

BEFORE INSTALLATION

BEFORE INSTALLATION

Installation Requirements

Details necessary clearances, base requirements, and piping for safe and efficient installation.

Water Connections

Piping Requirements and Safety

Details connection methods, safety warnings, and required valves for water piping.

ELECTRICAL WIRING

Wiring and Electrical Connections

Covers electrical installation requirements, safety, and code compliance for the heater.

WIRING DIAGRAM

Crosswind Inverter Models (30-1, 40-1, 50-1)

Provides the detailed wiring schematic for specific Inverter models.

Crosswind Inverter Model (65-1)

Displays the specific wiring schematic for the Crosswind 65-1 Inverter model.

CONTROLS

OPERATING INSTRUCTIONS

Start-Up Procedures

Outlines the steps for safely starting the pool heater.

TROUBLESHOOTING

Common Faults and Solutions

Lists common issues and their corrective actions for the pool heater.

Fault Codes

Details error codes displayed by the unit and their meanings.

TECHNICAL PARAMETERS

ILLUSTRATED PARTS LIST

Raypak CROSSWIND-65-I Specifications

General IconGeneral
ModelCROSSWIND-65-I
TypeSwimming Pool Heater
Heating Capacity65, 000 BTU/hr
Fuel TypeNatural Gas or Propane
Ignition TypeElectronic
Efficiency82%

Related product manuals