18
Interface introduction
Shovel the cured layer of resin along the edge of
the resin tank with the triangular scraper until it was
separated at the corner.
Please take the layer of solid resin with your hands
by wearing rubber gloves and discard it properly
afterward. It is not recommended to deal with that by
using the tools such as tweezers since the solid resin
with such thickness was quite brittle.
Step 3：
Clean up the cured resin within the tank.
Step 4：
Double check that whether there is residual fragment
within the resin tank, repeat the procedure above if
there is any.
Please get the resin material filtered before starting with
the printing task if there is lots of cured fragment after a
failed printing.
To Next Page
Loading...