RayTek MARATHON MR - Overview to Hold Functions

Operation
34 Rev. E2 04/2011 Marathon MR
6.2.5 Overview to Hold Functions
The following table lists the various Hold functions along with their resets and timing values. Use this
table as a guide for programming your sensor and adjusting the Hold times.
Please note, the setting of some commands is not possible by using of the control panel, these
commands are only available by means of the software.
Hold Function
RESET by
Peak Time
Valley Time
Threshold
Hysteresis
Decay Rate
Protocol code
P
F
C
XY
XE
none
none
000.0
000.0
-*
-*
-*
Peak Hold
timer
000.1-299.9
000.0
000.0
-*
000.0
Peak Hold
trigger
300.0**
000.0
000.0
-*
000.0
Peak Hold with decay
timer
000.1-299.9
000.0
000.0
-*
0001-9999
Advanced Peak Hold
trigger or
threshold
300.0
000.0
0250-3000
-*
0000
Advanced Peak Hold
timer or
threshold
000.1-299.9
000.0
0250-3000
-*
0000
Advanced Peak Hold with
decay
timer or
threshold
000.1-299.9
000.0
0250-3000
-*
0001-9999
* Value does not affect the function type
** Holds indefinitely or until triggered
Table 3: Hold Functions