Raytheon Beech Baron E55 - Page 880

Ray~heon
AiKraft
Company
BARON
55 AND 58
SHOP
MANUAL
1
GO-HOUR INSPECTION
(Contrnued)
B.
POWER
PLANT
(Continued)
MECH INSP
LH
RH
14.
ALTERNATOR
(Prestolite
or
Delco
Remy
only)
Remove and disassemble
the
alternator
as
necessary
to
inspect
the
rotor
shaft
bearings
for
condition and
replace
if
necessary.
Refer
to Service
Instruction No.
0546-359
Rev II
or
subsequent.
15.
STARTER
Check for
condition,
attachment and chafed
or
loose
wires.
16.
ALTERNATOR/GENERATOR
BELT
Check
for
proper
tension and
worn
or
frayed
condition.
Check tension
adjustment
bolt for
tightness.
17. MAGNETOS Check contact
points
for
proper
clearance. Points with
deep pits
or
excessively
burned
areas
must
be discarded.
Inspect
the
cam
follower
felt
pad
for
proper
lubrication
and clean the
compartment
with
a
clean,
dry
cloth.
Check
timing.
18.
IGNITION
HARNESS
Inspect
for
fraying
and
attachment.
19.
CYLINDERS
AND
BAFFLES Check
cylinders
and exhaust
manifold
for obvious
leaks,
security
and
cracks,
check baffles for cracks and
security.
Check
cylinders
for broken
cooling
fins and loose
or
missing
base
nuts.
20.
EXHAUST
SYSTEM Check
for
deformation,
security,
cracks, leaks,
loose
or
missing
nuts
and
clamps.
Check for
thin wall condition which
may
occur
due
to
normal internal erosion
on
stacks
which
have
long
service time.
21.
FIREWALL
Check
for
wrinkles,
damage
or
cracks.
Check
all electrical and
control
access
holes for
proper
sealing.
22.
HOSE
AND
DUCTS Check
all
fuel,
oil and air hose
or
duct
for
leakage,
cracks,
deterioration and
damage.
Check
fittings
for
security.
23.
ENGINE
ACCESSORIES Check
for
condition,
security
and leaks.
Check
wiring,
hoses
and tubes
for
chafing,
security
and leaks.
24.
ENGINE
MOUNTS
(TC-350;
TE-1
thru
TE-1201;
TH-1
thru TH-1610 without Kit
58-9007-1S
or new
engine
mount
P/N
96-910010-67)
Check for cracks
(refer
to
Raytheon
Aircraft Service
Bulletin No.
2362),
corrosion and
security. Inspect
rubber
cushions,
mount
bolts and
nuts,
and
grounding straps
for condition
and
security.
25.
PROPELLER GOVERNOR
Check for
leaks and control
arm
for
security.
26.
ENGINE CONTROLS Check
controls and
associated
equipment
for
condition,
attachment,
alignment
and
rigging.
Remove cable
connection
bolts
and check
for
wear
each
300
hours.
27.
ELECTRICAL
WIRING
AND
EQUIPMENT
Inspect
electrical
wiring
and
associated
equipment
and accessories for
fraying
and
attachment.
28.
PRESSURE
PUMP
INTAKE FILTER
Check
for
condition and
security.
Refer
to
Section
15
for additional information.
Page
6Dec
31/04
SECTION
16
E23