Safety Instructions
Prevent Electric Shock
▪ Parts of the laser head such as nozzle, sensor, sensor interface and attached fasteners may not
be fully protected by the ground wire due to function fault. These parts may have low voltage. When
installing electrical equipment, please pay attention to taking anti electric shock measures for relevant
personnel.
▪ Note that the equipment shall be grounded as specified.
Guard against Danger
▪ Never put your hands or other body under the laser head.
▪ Repair and maintenance work can only be carried out after the power is turned off.
▪ Do not exceed the specified maximum pressure.
▪ It must be ensured that the laser head is in normal condition at all times.
▪ All fasteners such as bolts and nuts must be tightened.
Laser Caution
▪ Avoid direct laser radiation or scattering to the skin.
▪ Do not stare at the laser beam even when wearing optical equipment.
▪ Use special laser protective eyeglasses that meet the requirements of safety standards IEC 60825-1.
Prevent Waterway Corrosion
▪ In order to avoid corrosion, use the specified coolant and comply with relevant requirements and
specified maintenance intervals.
Noise Prevention
▪ The corresponding measures shall be specified or explained and observed in order to prevent personnel
from being harmed by noise when the cutting air pressure is high.
Storage and Transportation
▪ Observe the storage temperature range allowed by the technical data.
▪ Take reasonable measures to prevent fire, vibration or impact.
▪ Do not store in or near the magnetic field.
To Next Page
Loading...
