5
ASSEMBLY AND SET-UP
Attaching the Handlebar Unit Cont.
Required Tool: 5 mm Allen wrench
Attaching the Seat
Required Tools: 5 mm Allen wrench, Phillips screwdriver, 13 mm wrench.
3 Reinsert the steering bolt and secure using the
5 mm Allen wrench.
1-1 Insert left foot support into seat.
3-1 Insert right foot support into seat.
1-2 Press firmly until click is heard.
2 Install the four (4) screws (included in bag with
the manual) using the Phillips screwdriver.
WARNING: Failing to
properly tighten the steering
bolt that attaches the front fork
assembly to the down tube
assembly can cause you to lose
control and fall.
To Next Page
Loading...
