RC Mowers TK-44E - Maintenance Schedule; Service Parts

SERVICE PARTS
Contact RC Mowers to purchase service parts for
your unit.
Description
Qty.
Part No.
Transaxle Drive Belt
1
850340
Mower Belt – Left 44"
1
850350
Mower Belt – Right 44"
3
850360
Mower Blade – 44"
3
850370
Hydraulic Oil – 32 oz.
1
850380
Hydraulic Oil Filter
1
850390
Fuel Filter
3
850400
Engine Oil Filter
3
850410
Air Filter
1
850420
Fuel Stabilizer – 118 ml (4 oz.)
A/R
>Except Canada
850430
>Canada Only
850440
HOUR/MAINTENANCE METER
Hour Meter-only Models
Timer measures engine runtime and cannot be reset.
Maintenance Models
When the key is in the on position, the Timer mode
displays. Press the Mode button to toggle between
different modes. (See Figure 14.)
Timer: Measures engine runtime until reset. To reset
the timer, press the Mode button to select TMR1
mode and then hold Mode button for 3 seconds.
IMPORTANT: Turn ignition key to the off
position
when unit is not in use. Some meters may count
hours when the key is in the on
position, even if the
engine is off. This results
in inaccurate maintenance
intervals.
Figure 14
Service Alerts: Counts down hours until
service is
needed and displays “Now” when service is due.
Service time is measured for:
• Engine oil and filter changes (CHG OIL)
• Hydraulic oil and filter changes (CHG H OIL)
• Air filter service (SVC AIRFILTER)
The service intervals preset into the hour meter are:
• Hydraulic oil and filter: First 75 hours and
every 400 hours thereafter
• Engine oil and filter: First 25 hours and every
100 hours thereafter
• Air filter: Every 100 hours
NOTICE: The preset engine oil services intervals are
normal recommended intervals. Specific engine
manufacturer’s
recommendations may vary.
To clear a service message, press the Mode button
to select Service Alert mode and then hold the Mode
button for 3 seconds.
CHECK PARKING BRAKE
IMPORTANT: Check brake on both sides of unit.
1. Place unit in service position. See Service
Position on page 17.
2. Bypass transaxles. See Move Unit Manually
on page 15.
3. Push unit forward.
• If unit does not move forward, no
adjustment is needed.
• If unit moves forward easily, adjust the
brake lever.
CHECK ENGINE OIL
NOTICE: Engine oil level must be maintained at
correct level or engine damage may occur. Refer to
engine manual.
TRACK TENSION
WARNING: Avoid Injury
Read and understand the
Safety
section before
proceeding.
Check Track Tension.
The rubber tracks may occasionally need a tension
adjustment, especially during the break-in period.
Track tension may be checked as follows:
1. Place the unit on a hard, level surface.
2. With the engine off, disengage the parking
brake.
18