MI2S-600D/700D/800D 04
Important Safety Instructions
Usage
Danger of high voltage
High voltage in the micro inverter can cause dangers to life.
Caution
Do not come within 8 inches ( 2 0 cm) of the micro inverter when it is in operation.
Beware of hot surface
The inverter can become hot during operation. Avoid contact with metal surfaces during
operation.
Read manual first
Please read the installation manual first before installation, operation and maintenance.
The MI2S-800D series micro inverter is designed and tested according to international safety requirements.
However, certain safety precautions must be taken when installing and operating this inverter. The installer
must read and follow all instructions, cautions and warnings in this installation manual.
• Ensuring that all tasks related to the transportation, installation, start- up, and maintenance of your equipment are
carried out by qualified and trained personnel is of utmost importance.
• It is recommended that you thoroughly inspect the product for any damage that may have occurred during
transportation before installation, as this may compromise the insulation integrity and safety clearances, potentially
leading to safety hazards. Additionally, it is crucial to carefully select the installation location and adhere to the specified
cooling requirements.
• To avoid damaging the equipment and causing serious safety and shock hazards, do not remove necessary protections,
engage in improper use, install the equipment incorrectly, or operate it incorrectly. It is essential to obtain necessary
approvals from the local power operator before connecting the micro inverter to the power grid, and only qualified
technical personnel should make this connection. The installer should also provide external disconnect switches and
Over Current Protection Devices.
• To ensure proper functioning of the equipment, each input of the inverter should only be connected to one PV module,
and batteries or other sources of power supply should not be connected. It is crucial to observe and apply all technical
parameters as specified. Additionally, avoid installing the equipment in flammable, explosive, corrosive, extremely
hot/cold, and humid environments, and do not use the equipment if safety devices in these environments are not
functioning properly. During installation, it is essential to use personal protective equipment such as gloves and goggles.
• If non- standard installation conditions arise, it is recommended that you inform the manufacturer. Do not use the
equipment if any operating anomalies are found. All repairs should be done using qualified spare parts that are
installed in accordance with their intended use by a licensed contractor or authorized Rockcore service representative.
Any liabilities arising from components not produced by Rockcore are the responsibility of their respective
manufacturers.
• Whenever the inverter has been disconnected from the public grid, exercise extreme caution as some components
may retain a charge that is sufficient to create a shock hazard. Before touching any part of the inverter, ensure that the
surface and the entire equipment are within the limit of safe temperature and voltage potential.
• Note that Rockcore is not liable for any damage caused by incorrect or improper operation. Electrical installation
and maintenance should be conducted by licensed electricians and should comply with local wiring rules.
To Next Page
Loading...