When installing, ensure that the AC output ground cable of the chassis and device is properly
grounded to avoid electric shocks.
Before installing, please read this manual carefully, especially the operation instructions about the
warning and attention marks.
All operation and wiring must comply with the relevant national and local standards.
The PV array provides a DC voltage to the micro inverter when illuminated.
Only professional electrical engineers can operate the micro inverter system and grid
connection.
When working for a long time in a high temperature environment, the temperature of the terminal
will exceed the limit of 60℃ .
The installation position shall not prevent disconnecting the power supply.
No RCD in the micro inverter, you have to prepare it in additional.
No user maintainable parts in the micro inverter, and high voltage may exist. Non- professional
maintenance personnel are forbidden to open the shell.
Suitable for areas below 2000m above sea level, derating if the altitude is higher than 2000m.
To Next Page
Loading...