No picture, no sound but
power light is on
• Maybe someone changed CABLE/AIR function to wrong position.
• Maybe a vacant channel is tuned.
• For Channels 91 and 92, make sure the component connected to INPUT 1 or 2 is
turned on in order to see picture.
• If watching VCR (connected only thru antenna input), make sure TV is tuned to
channel 3 or 4-same as CH3/CH4 switch on VCR. Also check to make sure TV/VCR
switch on VCR is in correct position.
Sound okay, picture poor • Check antenna connections.
• Try adjusting SHARPNESS function to improve weak signals.
Picture okay, sound poor • Try another channel.
• Try adjusting VOLUME, BASS, and TREBLE controls.
• If station is sending stereo, use Audio Menu function to put TV into "Mono" mode.
Controls don't work • If using remote control, make sure remote is in "TV Mode" by first pressing TV
button.
• Try unplugging set for 2 minutes and then turning it on again.
49
To Next Page
Loading...
