Operating Remote Control
The Digital Control remote not only
controls your new TV but several
other compatible RCA VCR models
as well.
Before attempting to operate your
remote control, install the batteries as
shown below.
-Effective Range of Remote
Control
The remote control produces an
invisible (infrared) beam that travels
in a straight line much as the beam
of a flashlight. For this reason, when
operating the remote control, you
must point it directly at the front of
the 'IV without objects between that
can block the infrared fight beam.
Aim remote at
your TV's remote
control sensor.
- Installing/Replacing Batteries
1. Turn the remote control face
down.
2. Press down on the ridged area
of the battery cover and slide it
off.
3. Install two "AAA" batteries as
shown. Make sure you match
the + end of each battery to
the + end of the battery
compartment.
4. Replace the cover and turn
remote over-face up.
Notes:
• Never place anything heavy on
top of the remote control or lay it
upside-down. This may
accidentally depress the buttons
for a long time and discharge the
batteries.
• Replace the batteries when the TV
fails to respond to the remote
control.
Remove the batteries from the
remote control if it will not be
used for a month or more. This
will prevent possible damage from
battery leakage.
To Next Page
Loading...
Need help?
General
