EN - 2
Remote Control
Battery Replacement
When the battery becomes weak, the
operating distance of the remote control
will be greatly reduced and you will need to
replace the battery.
Note:
• If the remote control is not going to be
used for a long time, remove the battery to
avoid damage caused by battery leakage
corrosion.
• Whendiscardingbatteries,environmental
problems must be considered and local
rules or laws governing the disposal
of these batteries must be strictly
followed.
WARNING:
• Donotdisposeofthebatteryinareorit
may leak and/or explode.
• Batteries should not be exposed to
excessiveheatsuchassunshine,reorthe
like.
CAUTION: Danger of explosion if battery is
incorrectly replaced. Replace only with the
same or equivalent type.
Remove the plastic sheet
before operating the
remote control.
To Change Remote Battery
1. Open the battery door.
2. Insert one CR2025 (3V) size battery.
Using the Remote Control
• Point the remote control at the REMOTE
SENSOR located on the unit.
• When there is a strong ambient light
source, the perform ance of the infrared
REMOTE SENSOR may be degraded,
causing unreliable operation.
To Next Page
Loading...
