EN - 9
This owner’s manual explains the basic instructions for operating this unit. Some
DVDs are produced in a manner that allows specific or limited operation during
playback. Therefore, this unit may not respond to all operating commands. THIS
IS NOT A DEFECT. Please refer to the instructions accompanying the specific
DVD in question for more information about the options available on that DVD.
“ ” may appear on the screen during operation. A “ ” means that the
desired operation is not permitted by the unit or disc.
Playing a Disc
1. Slide the STANDBY/ON switch to the ON position.
See CUSTOMIZING THE DVD FUNCTION SETTINGS before proceeding to step 2.
2. Press the button and hold the front panel to open the disc door.
3. Hold the disc by its edge and gently push it onto the spindle, with the label side facing
the front, until you hear a “click”.
4. Push the disc door gently to close it. It takes a short while for your unit to load the disc.
After loading, for most DVDs, the unit will automatically take you main menu of the
DVD or start playing the DVD.
5. If the unit does not automatically start playing the DVD, press the PLAY button.
Pausing Playback (Still Mode)
Press the PAUSE button. To resume normal playback, press the PLAY button .
For a DVD, each time you press the PAUSE button, the picture advances one frame.
Stopping Playback
Press the STOP button at the location where you want to interrupt playback. To resume
playback at the position where the disc was stopped, press the PLAY button.
If you press the STOP button twice, the unit’s memory will be cleared and pressing the
PLAY button will reset the disc to the beginning.
Fast Forward/Fast Reverse
1. Press and hold the or button when a disc is playing. Each time the or
button is pressed, the playback speed changes in the following sequence:
2. Press the PLAY button when you have reached the desired point to resume playback
at normal speed.
Playing a Disc - Basic Functions
Unit Operation
Turning the unit on
1. Slide the STANDBY / ON switch on the DVD player to the ON position.
2. The start-up picture will appear on the screens.
3. After use, slide the STANDBY / ON switch on the DVD player to STANDBY (power off).
To Next Page
Loading...
Need help?
General
