Connections & Setup
Why You Should Connect This G-LINK Cable
Tile G-LINK cable enables the GUll)E Plus+ system (the (m screen interactive prognun guide) to
work with your VCR and/or cable box.
Cable Box- If your TV is connected to a cable box you must connect tile G-LINK cable to
receive TV program listings for your area, and to tune directly to a channel when the program
guide is on your TV screen.
VCR-If your "IX_is connected to a VCR and you don't connect the G LINK cable, one touch VC|;{
recording won't work. "Fhe other leatures of the guide will v,,ork properly
le
G-LINK wands
How to Find the Remote Sensor
You have to place the G-LINK wands in front of the remote sensor on the VCR and/or cable hox.
Some cable boxes and VCRs have the remote sensor labeled on the unit. If the remote sensor
isn't labeled on your VCR and/or cable box, you need to use the lvmote control that came with
the VCR and/or cable box to locate the sensor.
1. Turn off the VCR and/or cable box.
2. Hold the remote control (not the one that came with your TV, hut the one that came with
the cable box and/or VCR to which you're attaching the G-LINK cable) so that it is touching
the front of the component.
3. Slowly move the reniote control across the front of the component (VCR or cable box) while
you press the power button on and off. You must press and release the power button each
time you move the remote (holding down the button won't work).
II II
4. When the component turns on, you've located the remote sensor.
If you don't have both a
cable box and a VCR
connected to your T_,
just coil the cable of the
extra G-LINK wand with a
twist tie and leave it
behind the T_
Placing the G-LINK Wands
Place the G-LINK wands in front of the remote sensor on your VCR and/0r cable box
approximately one inch away from the remote sensor (see instructions below).
TV(back_amell
Chapter 1 13
To Next Page
Loading...
Need help?
Picture
Weight and Dimensions
