Using.Your TV and Remote
With VCRs: Setting the VCR 1 Channel
The VCR 1 Channel works with VCR1 button on the remote. If the VCR 1
Channel is set, pressing VCR1 selects the channel to see the VCR picture.
The VCR 1 Channel setting depends on which diagram you have used
from the Connection Guide. If you want to turn this feature off, set the
VCR 1 Channel to Disable. Refer to the chart below for your setting.
1. Select the Setup Menu
3ontrols Alarm Ad
13
A. Press "D/to set the remote to
control the TV.
B. Press MENUoPROG to select the
Setup menu. This menu is
white.
2. Highlight VCR1 Channel
Alarm
13
A. Press MOVE • to highlight the
VCR 1 Channel.
B. Press MOVE _ to highlight the
channel.
3. Enter channel number
Contr Alarm
13
Enter channel 00, 03, or 04. Choose
your setting from the chart below.
Press CHANNEL down until
"Disabled" is displayed to turn the
feature off.
Diagram used from the !
Connection Guide: j Set VCR 1 Channel to:
1B' iC, 2B, 2C, 3B, 3C' 4C, 5C .... _i! 00
4B, 5B
i 3 or 4 (same as 3/4 switch)
9
To Next Page
Loading...
