Using Your TV and Remote
With a Laserdisc Player: Programming and Basic Operation
Refer to your Laserdisc Player owner's manual to hook up your Laserdisc Player.
The remote may need to be programmed for your laserdisc player, but may
not operate all models of the brands listed below. Use the codes below or on the
sheet packed in with your remote.
Program the remote for
your Laserdisc Player
Basic OPeration
90_.R VCR1 SATeCAB/.E T_'
D
REW PLAY FF
REC STOP PAUS[
DISPLAY SKIP
0 _'" 0
CHA_ _EV CH
4 0 5O 6 0
'O
INPUI"o 00 ANTENNAo
x7
A. Point the remote at the laserdisc
player and hold VCR2. LD.
B. Enter the code for your brand
from the code list below.
C. Release VCR2°LD.
D. Press POWER. If nothing
happens, try pressing
VCR2oLD and then POWER.
A. Tune TV to channel 00, 03,
or 04.
B. Point the remote at the laserdisc
player and press VCR2o LD.
C. Press POWER to turn it on.
D. Use the buttons on the remote
that relate to laserdisc player
functions. Not all buttons
highlighted may work with
your laserdisc player.
E. Press POWER to turn it off.
Laserdisc Player Codes
"1
Pioneer ........................ 33 I
ProScan.....................:.33
|
RCA.............................33
- _. , __
14