Using Your TV and Remote
With a Satellite Receiver: Basic Operation
You may also be able to use the TV's remote with satellite receivers. R_Cer
to your Satellite Receiver owner's manual to hook up your Satellite Receiver.
The remote may need to be programmed for other brands of satellite
receivers, but may not operate all models of the brands listed below. Use
the codes below or on the sheet packed in with your remote.
Follow the instructions below for basic operation of your receiver. You
may also want to experiment with other buttons on the remote to see if
they work with your receiver.
Program the remote for your
Satellite Receiver
Turn on the Satellite
Receiver
Turn off the Satellite
Receiver
Satellite Receiver Codes
Chaparral..........................80)31 i
Cheyenne ...............................81
Drake.................................82,83 |
:::::::::::::::::::::::::::::::::::::::::::::::|
General Instruments...92,93,94 U_
ProScan...................................00 _.
RCA ......................................... 00 B
Realistic ..................................84 I
Sierra I,II,HI............................ 81 i
STS1.........................................85 _
srsz ........................................86 |:
STS3.........................................87 _
_J4...,o°.,..o. ,..,, ..o.....o.. ...... ...,...88 "
NI
Toshiba................................... 89 _[
Uniden ................................... 90 m_:
<G [::>
A. Point the remote at the satellite
receiver and hold SAT*CABLE.
B. Enter the code for your brand
from the code list below.
C. Release SAT*CABLE.
D. Press POWER. If nothing
happens,trypressing
SAT*CABLE and thenPOWER.
A. Press SAT*CABLE to set
the remote to control the satel-
lite receiver.
B. Press POWER to turn on the
receiver if it did not turn on
when you pressed SAT*CABLE.
A. Press SAT*CABLE to set
the remote to control the satel-
lite receiver.
B. Press POWER to turn off
the receiver.
11
To Next Page
Loading...
Need help?
General
