Other Information
Chapter 5
Remote Control Doesn’t Work
Remote Control Doesn’t Work
• Something might be between the remote and the remote sensor on the component. Make sure there is a clear path.
• Maybe the remote isn’t aimed directly at the component (TV or VCR) that you’re trying to operate.
• Maybe remote is not in TV Mode. Press the TV button so remote will control TV.
• Maybe batteries in remote are weak, dead, or installed incorrectly. Put new batteries in the remote. (Note, if you remove the
batteries, you may have to reprogram the remote to operate other components.)
• You might need to drain the remote’s microprocessor: remove batteries and press the number 1 button for at least 60 seconds.
Release the 1 button, replace the batteries, and (if necessary) program the remote again.
The rating limits don’t work
• You must lock the settings. Go to the
(press MENU on your remote), select
MAIN MENU (press MENU on your remote), select MAIN MENU
password and I want to unlock the TV
• If you forget your password, press MENU, then select
(the password entry screen appears). Simultaneously press
and hold CH+ and VOL+ on the TV’s front panel for 8 seconds. The Parental control menu appears on the screen, and you can re-
The V-Chip won’t let me watch a program even though it’s not rated as violent.
• Maybe the movie was given an NR (Not Rated) status. After you block movie ratings, you must set
View separately in order to View
view movies with an NR rating.
To Next Page
Loading...
