RCA hd52w67 - Other Information

Other Information
Chapter 5
55
Chapter 5 55Chapter 5
Continues on next page...
Sound okay, picture poor
• Check antenna connections. Make sure all of the cables are fi rmly connected to the jacks.
• Try adjusting sharpness function to improve weak signals. Go to page 45 for more instructions.
Can’t select certain channel
• Make sure the remote control is in TV mode. Press the TV button and enter the channel number using the number buttons.
• Channel may be blocked or not approved in the
Parental Controls
menu.
Parental Controls menu. Parental Controls
• If using a VCR, check to make sure the TV/VCR button on the VCR is in the correct mode (press the TV/VCR button on your VCR).
Noisy stereo reception
• May be
a weak
station. Use
Sound
menu to choose mono sound.
No picture, no sound but TV is on
• Maybe the cable/air function is set to the wrong position. Go to page 48 for detailed instructions.
• The channel might be blank — change channels.
• If you’re watching your VCR and it’s connected with coaxial cable to the CABLE/ANTENNA jack, tune the TV to channel 3 or 4
(whichever channel is selected on the 3/4 switch on the back of your VCR). Also check to make sure the TV/VCR button on the VCR
is in the correct mode (press the TV/VCR button on your VCR).
Volume buttons not adjusting volume louder
• Check to make sure volume isn’t limited by the maximum volume feature. Go to page 48 for more instructions.
Picture not moving
• You have activated the Freeze feature by pressing FREEZE or OK on the remote. Press any button to “unfreeze” the picture.
Black box appears on the screen
• Closed-captioning might be on. Check
Closed Caption
in the
Setup
menu. Go to page 49 for more instructions.
Setup menu. Go to page 49 for more instructions.Setup
Freeze not working
• The freeze feature is not available for Component video (CMP1 or CMP2) or DVI inputs.
Low battery warning appears on screen
• Place new batteries
in remote.
TV picture keeps switching between
screen formats abruptly
• Switch the
Auto
format
feature to
Off
. See page 44 for more information.
Off. See page 44 for more information.Off
Channel search fi nds few channels
• The cable connected to the ANTENNA/CABLE ANALOG INPUT and/or ANTENNA DIGITAL INPUT jack might be loose.
• Your off-air antenna might be getting a weak signal. Move it higher or get a bigger antenna.
• If you have cable TV, make sure that signal is connected to the ANTENNA/CABLE ANALOG INPUT—do not connect it to the
ANTENNA DIGITAL INPUT.
• If you have a cable box, you can’t connect it to the ANTENNA DIGITAL INPUT jack. Connect it to the ANTENNA/CABLE ANALOG
INPUT or a Video Input jack.
• Select the
Both
option in the Channel Search menu, and retry the channel search.