7
FIRST THINGS FIRST
USING THE BELT CLIP
Your scanner has been
equipped with a belt
clip to make it more
mobile. To use, simply
slide the belt clip over
the waistband of your
pants/skirt or your
belt.
USING THE LIGHT
Your scanner has been
equipped with a light
to help you see better
in dim or dark lit areas. Press the
LIGHT button again to turn the light
off before the 5 seconds are up.
BATTERY SAVER
Your scanner has been equipped with
a battery-saving circuit. This feature
sends the unit into a standby mode,
which uses only 40 percent of the
available power, if no signal is
detected within a 5 second time
interval, P-SA(power save) appears in
the display.
The scanner will continue to operate
in the standby mode until it receives a
signal or you press a button.
HAVE A BLAST - JUST NOT IN
YOUR EARDRUMS
Make sure you turn down the
volume on the unit before you
put on headphones. Increase the
volume to the desired level only
after headphones are in place.
• Do not operate your scanner at
high volume. Hearing experts
advise against continuous
extended play.
• If you experience a ringing in your
ears, reduce volume or discontinue
use.
• You should use extreme caution or
temporarily discontinue use in
potentially hazardous situations.
Some headphone/earphones
allow you to hear background
noise while listening to your
scanner at a normal volume
setting. Regardless, wearing
headphones or an earphone while
riding a bike or operating a vehicle
cannot only impair your concentra-
tion, it is also dangerous and/or
illegal.
To Next Page
Loading...