RCA RP-6198

14
USING THE SCANNER
1. Press MAN.
Use the number pad to enter the car
number containing the frequency. If
your scanner displays a frequency
other than the one you want to
change at the same car number,
press one of the search arrows (
or ) until the frequency you
want to change is shown in the
display.
2. Press 0, then press ENT-L/OUT.
The frequency is deleted.
3. Enter the frequency number.
4. Press ENT-L/OUT.
USING PRIORITY SCAN
When you designate one channel as
the priority, the scanner will check it
every two seconds and will remain
there if an active transmission is in
progress. Pch will appear in the
display on the left whenever the
scanner switches to the priority
channel.
1. Press the PROG button.
2. Press the PRI button.
3. Enter the frequency you want to
store into a priority channel.
4. Press the ENT-L/OUT button.
To activate the priority scan, press
the PRI button while scanning. PRI
will appear from the display. To turn
off the feature, press the PRI button.
PRI will disappear from the display.
MONITOR MEMORY
Once you have temporarily stored a
frequency in a monitor memory, you
need to decide whether or not you
want to store it permanently in a
channel.
Remember that monitor
memories are not scannable.
TO LISTEN TO A FREQUENCY IN
MONITOR MEMORY
Since you cannot scan monitor
memories, you must manually select
the frequency you want to hear.
1. Press the MAN button.
2. Press the MEM button.
3. Press the number key of the
monitor memory location you want
to hear.
4. Press the MEM button.
STORE THE FREQUENCY IN
MONITOR MEMORY
When the scanner stops on an active
frequency and you want to tempo-
rarily save it, press the MEM button to
store it in the monitor memory with
the flashing indicator beneath it.
If you do not want to save the active
frequency, press either or to
continue the search.