AUTO CHANNEL SEARCH
Nou scann4ng channel 14
Press any key to cancel
The VCR begins scanning for the available channels--this
takes about one to two minutes. The lowest channel istuned
once the search is complete. Now, pressing CHANNEL up or
down should only select the active channels.
To Change the Signal Type
1. PressMENU to display the VCR MAIN MENU.
2. Press4 to display the CHANNELS menu.
3. Press 3 to change the SIGNAL TYPE between CABLE and
ANTENNA.
To ADD or REMOVE Channels
You may want to add or remove channels after you AUTO
CHANNEL SEARCH, especially if some of the channels have weak
signals or you don't want to watch them.
1. Press MENU to display the VCR MAIN MENU.
2. Press4 to display the CHANNELS menu.
3. Press2 to display the ADD/REMOVE CHANNELS screen. Use
CHANNEL up or down or number buttons to go to the
channels you want to remove or add.
ADD/REMOVE CHANNELS
Channel 115
ts presently ADDED
Press CLEAR to remove
Press MENU to exit
ADD/REMOVE CHANNELS
Channel 115
is presently REROVED
Press INFO to add
Press MENU to exit
Selecting Channels
The CHANNEL up and down
buttons accessthose channels
active in your VCR channel list.
You can still accesschannels not
in the channel list by using the
number buttons on the remote.
11
To Next Page
Loading...
