5
ENGLISH
To prevent the risk of falling equipment, do not stack multiple units of this product unless this
possibility is specied in the user manual.
8. RCF S.p.A. strongly recommends this product is only installed by professional qualied
installers (or specialised rms) who can ensure correct installation and certify it according to
the regulations in force.
The entire audio system must comply with the current standards and regulations regarding
electrical systems.
9. Supports and trolleys
The equipment should be only used on trolleys or supports, where necessary, that are
recommended by the manufacturer. The equipment / support / trolley assembly must be
moved with extreme caution.
Sudden stops, excessive pushing force and uneven oors may cause the assembly to overturn.
10. Hearing loss
Exposure to high sound levels can cause permanent hearing loss. The acoustic pressure level
that leads to hearing loss is different from person to person and depends on the duration
of exposure. To prevent potentially dangerous exposure to high levels of acoustic pressure,
anyone who is exposed to these levels should use adequate protection devices.
When a transducer capable of producing high sound levels is being used, it is therefore
necessary to wear ear plugs or protective earphones. See the manual technical specications
to know the maximum sound pressure level.
11. Situate this product far from any heat sources and always ensure adequate air circulation
around it.
12. Do not overload this product for a long time.
13. Never force the control elements (keys, knobs, etc. ).
14. Do not use solvents, alcohol, benzene or other volatile substances for cleaning the
external parts of this product.
Use a dry cloth.
15. Do not put microphones close and in front of speakers, in order to avoid audio feedback
(‘Larsen effect’).
To prevent the occurrence of noise on microphone / line signal cables, use screened cables
only and avoid putting them close to:
- Equipment that produces high-intensity electromagnetic elds.
- Mains cables.
- Loudspeaker lines.
The equipments considered in this manual can be used in electromagnetic
environment E1 to E3 as specied on EN 55103-1/2: 2009.
NOTES ABOUT AUDIO SIGNAL CABLES
Note: This equipment has been tested and found to comply with the limits for a Class A
digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide
reasonable protection against harmful interference when the equipment is operated in a
commercial environment. This equipment generates, uses, and can radiate radio frequency
energy, and if it is not installed and used in accordance with the instruction manual, it
may cause harmful interference to radio communications. Operation of this equipment
in a residential area is likely to cause harmful interference, in which case the user will be
required to correct the interference at his own expense.
Modications: Any modications made to this device that are not approved by RCF may
void the authority granted to the user by the FCC to operate this equipment.
FCC NOTES
To Next Page
Loading...
Need help?
General
