RCF HDL 12-AS - Page 17

1. FLYBAR SETUP
The HDL6 flybar allows to set the central bar in two different configurations “A” e “B”.
Configuration “B” allows a better upper inclination of the cluster.
1.1 SET THE CENTRAL BAR IN “B” POSITION
1. Remove the cotter pins “R”, pull out the linchpins “X” and the
quick lock pins “S”
This accessory is provided in “A” configuration.
To set it in “B” configuration:
3. Re-assemble the flybar repositioning the pins “S”, the linchpins
“X” and the cotter pins “R”.
2. Lift the central bar then re-position it making the “B” indication
on the label and the holes “S” match together.
CENTRAL BRACKET LABEL
X
S
S
R
X
S
S
R
X
S
S
R
X
S
S
R
X
S
S
R
FLYBAR
WITH CENTRAL BAR
IN “A” POSITION
FLYBAR
WITH CENTRAL BAR
IN “B” POSITION