Need help?Do you have a question about the RCF NX M10-A and is the answer not in the manual?
General| Power Output (Peak) | 1400 W |
|---|---|
| Power Output (RMS) | 700 W |
| Woofer | 10" |
| Compression Driver | 1.4" |
| Horizontal coverage angle | 90° |
| Vertical coverage angle | 60° |
| Input connector | XLR, Jack |
| Output connector | XLR |
| Protections | Thermal, RMS |
| Limiter | Soft limiter |
| Controls | Volume, EQ |
| High frequencies power (Peak) | 400 W |
| High frequencies power (RMS) | 200 W |
| Low frequencies power (Peak) | 1000 W |
| Low frequencies power (RMS) | 500 W |
| Cooling | Convection |
| Color | Black |
| Height | 500 mm |
| Width | 320 mm |
| Frequency Response | 50 Hz - 20 kHz |
| Input sensitivity | +4 dBu |
| Crossover frequencies | 1.8 kHz |
| Power connector | PowerCON |
| Cabinet Material | Plywood |
| Hardware | M10 |
| EQ Settings | Boost |
| Type | Active 2-way Speaker System |
| Input signal | balanced/unbalanced |
To Next Page
