10
11
WARNING
Pushing the rear encoder it is possible to select the following three functions:
- input gain reduction
- speaker delay setting
- selection of a speaker preset
Pushing once the rear encoder the gain reduction LED will light up. Now rotating the
encoder counter clockwise it will be possible to reduce the input gain. The gain reduction
will be in steps of 0,1 dB for the first 10 dB and than in 1 dB steps.
The maximum reduction is 99 dB.
Pushing a second time the rear encoder the delay LED will light up. Now rotating the
encoder clockwise it will be possible to delay the signal output of the speaker.
The delay is expressed in meter. The delay will be in steps of 0,1 m for the first 10 m and
than in 1 m steps. The maximum delay will be 20 meter.
THE REAR ENCODER
CONTROL AND
SPEAKER SETTING
INPUT GAIN REDUCTION
SPEAKER DELAY SETTING
AC INPUT. Powercon locking 3-pole AC mains.
AC OUTPUT. Powercon locking 3-pole AC mains output.
WARNING: the Powercon connector is used to disconnect the system from the power supply
network. It shall be easily accessible after the instillation and during the use of the system.
10 11
To Next Page
Loading...
