Re WG251 SKB-C RESMART - Moving the Actuator

Re S.p.A. WG251 SKB-C RESMART
22/11/12 11/25
Press the write key to confirm the value set on the set point and go back to the
operating window.
Attention!
After about a minute of inactivity the set point change is disabled automatically,
and it goes back to the operating window.
HOW TO MOVE THE ACTUATOR
The actuator can only be moved in MAN status, therefore if it is in the AUTO status (
on the display), press the manual key.
WHAT TO DO
Press the + or – keys to move the actuator.
Press the servo center key to position the actuator at the centre of its stroke.
Attention!
By pressing the servo center key the actuator will start moving. To interrupt the
movement, press the servo center key once again.