Reach PoE4N Tester Manual 1.4 08/09/2017 Page 21
Appendix A - Operational Notes
A.1 Power-on
When the unit is powered on, it performs a self-calibration of its power load. This takes
around 10 seconds. While calibrating, the unit flashes the front panel LED and displays
the following. The prompt "RT-PoE4N>" indicates that the unit is ready for commands.
RT-PoE4N>”(revision dependent version string)”
Calibrating all ports..
:p1 Autocal OK
:p2 Autocal OK
:p3 Autocal OK
:p4 Autocal OK
:p5 Autocal OK
:p6 Autocal OK
:p7 Autocal OK
:p8 Autocal OK
:p9 Autocal OK
:p10 Autocal OK
:p11 Autocal OK
:p12 Autocal OK
:p13 Autocal OK
:p14 Autocal OK
:p15 Autocal OK
:p16 Autocal OK
:p17 Autocal OK
:p18 Autocal OK
:p19 Autocal OK
:p20 Autocal OK
:p21 Autocal OK
:p22 Autocal OK
:p23 Autocal OK
:p24 Autocal OK
RT-PoE4N>
To Next Page